Shuttle Slide DPA-1 TM Deck Plate

THIS ITEM IS SOLD ONLY AS AN UPGRADE TO HD OR UHD MOUNTS

Finally!  A UNIVERSAL deck plate adapter!  NO NEW
HOLES IN YOUR DECK!

Tired of drilling holes in your boat?  We don?t blame
you!  Add this universal deck plate adapter option to your order and you
are all set to add a ShuttleSlide mount in place where you previously hard
mounted your motor. This plate replaces the bottom plate on any of our
HD or UHD mounts.  Just copy the hole locations from your deck over to the
plate and you are good to go!

Made from 0.375? thick high strength and corrosion resistant
6061-T6 Aluminum, this adapter plate allows you to install any of our mounts in
the same location as your previously installed trollling motor using
the same holes.  This improves the strength and durability of your
deck while also ensuring that the installation of a ShuttleSlide mount will
result in the trolling motor being located exactly as it was before but with
the new ability to now retract the motor safely inside the boundary of the
vessel!

See it in action on the bow of this Rabloa Cayman 246!

• Designed
  to be used with the following trolling motors that share the same bolt
  patterns:
• Minn
  Kota: Ulterra, Terrova, Powerdrive, Riptide Ulterra, Riptide
  Terrova, Riptide Powerdrive, Riptide SP/ST, PD/HC Pontoon and DH40 
  in any shaft length or voltage configuration
• Minn
  Kota (See note below for these motors): Fortrex,
  Maxxum, Edge and other models that share the same ?Scissor? style
  deployment
• MotorGuide: Xi5
  and Xi3 in any shaft length or voltage configuration
• Rhodan
  HD GPS anchors
• Garmin
  Force Kraken
• Power
  Pole Move PV (ZR requires use of our TMA-1)
• Lowrance
  Ghost (requires use of our TMA-1)
• Haswing
• Water
  Snake models
• Many
  other brands that share the same bolt patterns as above
• Fully
  compatible with all ShuttleSlide HD and UHD mounts such as, SS-7-HD, SS-9-HD and SS-X-HD

Note:  These ?Scissor? style deployment
motors have a larger base footprint than other models.  The DPA-1 will
come with only the holes needed to attach a ShuttleSlide mount .  You will
need to use the holes in your deck as a pattern and add those holes to the
DPA-1.  This will prevent the need for new holes in your deck for these
?Scissor? style trolling motors.  Most of the time our customers are
looking for an adapter to convert from the scissor style system to the system
use on Ulterra, Terrova, Riptide, etc and this plate covers that need.

Dimensions

• Length: 
  16.625 Inches
• Width:
  6.0 Inches
• Thickness: 
  0.375 Inches